PocketTRS Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an enclosure for Arno Puder's PocketTRS. It's an awesome project, so I thought I would show it a little love.…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
This is an enclosure for Arno Puder's PocketTRS. It's an awesome project, so I thought I would show it a little love. there are 4 parts in total. two feet with pegs to be glued into the base, the base, and the lid. :) It's made to look like a TRS-80 Model 1 expansion interface. :) This was designed with the V2.1 in mind, but the differences between v2.1 and 2.2 should not make a difference, but I don't have one to test with. :). The base should hold both boards.
The top should be printed brim down, with supports so the finished side is up, for a better finish. The bottom should be printed bottom down, with supports for the opening in the back, you can clip these off after it prints. :) Printed on a CR-10, but it less than 8" wide so most printers should be able to handle it. :)
added NewBody and NewLid stl files as well, better fit for lid and body.
I added versions of the small enclosure with supports built in, and also another lid, with a slightly deeper lip, you might have to trip it a bit if you install a 3mm power led. :)
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
15 to 20
Filament: DigitMakers PLA Post-Printing =============
Just clip the supports in the openings. :)
Category: Computer