Electronics Enclosure (DSO 138 + others)

Electronics enclosure for:

• DSO138 Oscilloscope (https://www.aliexpress.com/item/32777588244.html)
• LCR-T4 tester (https://www.aliexpress.com/item/32680013678.html)
• PWM signal generator (https://www.aliexpress.com/item/32962154918.html)
• XR2206 signal generator (https://www.aliexpress.com/item/32781753613.html)
• LM7809 voltage regulator (https://www.aliexpress.com/item/32961984080.html)

Recommended BOM

• 4 M3 X 6 X 5.3 Embedded Nut (old link no longer works - possible substitution M3 X D5 X L6) https://www.aliexpress.com/item/4000232858343.html
• 12 M3 X 3 X 5.3 Embedded Nut https://www.aliexpress.com/item/32974153070.html
• 16 M3 Machine Screw https://www.aliexpress.com/item/32798146322.html
• Note this takes up almost the full print bed of the Ender 3 - use caution when positioning clips
• Updated 7/30/2019 to optimize switch orientation for printing

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

Doesn't Matter

Supports: 

No

Filament: Generic PETG Post-Printing =============

Embedded nut placement

Devices secured

• note wiring between LM7809 output and device inputs still needed. For input I've included a slot for a 5.5 X 2.1 jack to the left of the XR2206 signal generator and a small opening directly under the LM7809 (for direct wire) as two options. Note LM7809 input should be at least 12V DC - output is described as 9V max 1.2 A

7/30/2019 updated switches will need to be cut out of the cover and the ad-hoc "raft" trimmed off

Category: Electronics