Dust sensor case (@airrohr) M3 only
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I modified the holes to be M3 only, because that's what I have and what I like to use. The NodeMCU might require to…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 398
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I modified the holes to be M3 only, because that's what I have and what I like to use.
The NodeMCU might require to enlarge the holes a little bit with a drill, but I tried and you can also use M3 as is.
In my case, I didn't want to have a loose-jumper cables-setup so I chose to put some headers on a piece of perfboard and use the cable that came with the SDS011 so it's plug-and-play, more error-resistant (no cables falling out or something) while still not requiring soldering the ESP board into the project so it can be reused.
I then put a large enough hole into the perfboard and that's my setup.
I'm not too sure if the rest of the project uses any M2 screws, if it does I will modify those files and upload them here as well!
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
25
Category: Electronics