Dust sensor case (@airrohr) M3 only
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I modified the holes to be M3 only, because that's what I have and what I like to use. The NodeMCU might require to…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 17
- Makes
- 0
- Views
- 398
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I modified the holes to be M3 only, because that's what I have and what I like to use.
The NodeMCU might require to enlarge the holes a little bit with a drill, but I tried and you can also use M3 as is.
In my case, I didn't want to have a loose-jumper cables-setup so I chose to put some headers on a piece of perfboard and use the cable that came with the SDS011 so it's plug-and-play, more error-resistant (no cables falling out or something) while still not requiring soldering the ESP board into the project so it can be reused.
I then put a large enough hole into the perfboard and that's my setup.
I'm not too sure if the rest of the project uses any M2 screws, if it does I will modify those files and upload them here as well!
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
25
Category: Electronics