Remixed helical gear vases with base using 608 bearings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix from MyTechFun to fit 608 skateboard bearings at the base of the vases
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 302
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution
I partially printed the original design and decided I wanted to remix to make them spin a bit more easily. In keeping with the vase mode print, I had to bump up to 34 bottom layers with a .32 layer height to fit the bearing in. Uses around 90g filament per vase.
Bearing recess is 8mm tall, I added another 2mm to that to figure out roughly where to set my layer count to that'd give it a little support above. Still around a 4 hour print at 100%, up from the 2-3 hours of the original model.
Adjusted base to have a slight step to support the bearings and down to 7.75mm diameter for the bearings to be an easy fit.
Vase settings:
.32 layer height, .2 first layer
230c w/ hardened tool steel 0.6mm nozzle
0.8mm walls
80mm/s perimeters
Inland Silk Lime and Silk Copper filament
Base printed at .24 layer height, 15% grid infill, using Inland Twinkling Black. First layer slow, at 15mm/s, this stuff does not like to stick on my PC build plate.
Printed on CR10s pro w/ whambam PC flex plate, Microswiss M2 0.6 nozzle.