Remixed helical gear vases with base using 608 bearings
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix from MyTechFun to fit 608 skateboard bearings at the base of the vases
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 42
- Makes
- 1
- Views
- 302
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution
I partially printed the original design and decided I wanted to remix to make them spin a bit more easily. In keeping with the vase mode print, I had to bump up to 34 bottom layers with a .32 layer height to fit the bearing in. Uses around 90g filament per vase.
Bearing recess is 8mm tall, I added another 2mm to that to figure out roughly where to set my layer count to that'd give it a little support above. Still around a 4 hour print at 100%, up from the 2-3 hours of the original model.
Adjusted base to have a slight step to support the bearings and down to 7.75mm diameter for the bearings to be an easy fit.
Vase settings:
.32 layer height, .2 first layer
230c w/ hardened tool steel 0.6mm nozzle
0.8mm walls
80mm/s perimeters
Inland Silk Lime and Silk Copper filament
Base printed at .24 layer height, 15% grid infill, using Inland Twinkling Black. First layer slow, at 15mm/s, this stuff does not like to stick on my PC build plate.
Printed on CR10s pro w/ whambam PC flex plate, Microswiss M2 0.6 nozzle.