MPCNC Mounts for Endurance Laser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This contains a 3d model of the 8.5w laser I got from Endurance Lasers, as well as 2 mount options to attach it to the…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This contains a 3d model of the 8.5w laser I got from Endurance Lasers, as well as 2 mount options to attach it to the MPCNC.
The model isn't perfect, but all the dimensions are accurate enough.
The laser attaches with 4 M3x12mm screws.
Mount option A keeps the laser above the bottom of the carriage, so the laser can`t possibly hit the workpiece even if it goes down too far. However, with it only supported by 2 screws it might tilt every so slightly.
Mount option B doesnt extend as far, but can be mounted higher on the machine for the same effect. Its attached by 4 screws so tilting isn`t an issue. I recommend this one.
The fusion 360 models for both are included so you can customize to your liking.
Category: DIY