Full length door handles - knobs at the top with embedded magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
for better stability
- Ocena
- 4,8 / 5
- Polubienia
- 24
- Pobrania
- 113
- Wydruki
- 5
- Wyświetlenia
- 913
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I didn't want the closing mechanism to be at the bottom, because the door stop would need to be at the bottom as well, which can be an obstacle. That's why I put it all to the top. Also the smaller hinges/handles seemed a bit week, which is why I created these long ones.
To place the magnets, put a pause at layer 42 (8.4 mm) in your slicer. The provided gcode already has the pause. You will need 20x6x1,5 mm magnets. I bought theses from amazon:
They have to be this size, others will not fit. The space that is left for the magnet is about 0.1 mm bigger, so just enough to have a tight fit and avoid pulling the magnet out with the nozzle. (never happened to me, but I think this can happen). Be sure to clean your nozzle during the pause, or there will be debris when you continue the print.
The gcodes have a 4 mm brim added, which I highly recommend. The parts will warp otherwise if the temperature is not stable enough in your environment.