Corsair 280X Feet Extensions
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This case is wonderful, but it has one big problem. The original feet are to short (10mm).
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 123
- Wydruki
- 2
- Wyświetlenia
- 616
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This case is wonderful, but it has one big problem. The original feet are very short (10mm). If you install a large graphics card, it doesn't get enough airflow from the bottom side. These feet are a "drop in" replacement, just unscrew the old ones and screw them back on with the SAME screw. So that the feet do not pass on any vibrations, I recommend sticking the rubber from the old ones to the new ones.
Needed parts:
- Just the original screws
Print Settings:
- i printed mine with 0.2 height and 0.4 width, but i should work with another settings.
- Supports? Not needed.
- This was printed on a Custom CoreXY Printer, so the gaps and clearances that I designed in the model might not be optimal for your printer!
Print Time: (on my Printer)
- All 4 at once: 46m