Slat Mount For Matx Motherboards

designed for slat-wall at work to allow for interchangeable cloning machines. should be compatible with most slat-wall designs.

a few parts you will need to buy/have.

-motherboard standoffs (i used m3)

-screws

-and heat inserts

-drill

-something to mark the print with.

steps to make your own

1. take print and put motherboard against it.
2. mark out locations for where to drill based on motherboard mounting positions.
3. drill holes and use a soldering iron to install heat inserts. i used a smaller bit to start.
4. make sure all the inserts are straight and lined up
5. install the standoffs, doesn't really matter on length.
6. screw motherboard to plate (not to tight just want to make sure its snug.)

parts used

-insert m3x8x5mm 6

-standoffs m3x5 6

-screws m3x5 6

print settings

Ender 6 (print fit on modified ender 3v2 barely)

200C PLA creality white filament

60C bed

20% gyroid infill.

for power button is used a cherry mx switch i had sitting around

technically this is a work in progress, but it works great.

things i might change

-measure out holes so you do not have to use a drill.

-make longer to fit some Matx boards