1 / 2
BTT Octopus bracket for Fokoos Odin5-f3 — zdjęcie 1
1 / 2

BTT Octopus bracket for Fokoos Odin5-f3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

mount a BTT octopus in a Fokoos Odin5-f3 uses heat inserts You'll have to raise the printer, and lose the cover

Ocena
0 / 5
Polubienia
4
Pobrania
20
Wydruki
0
Wyświetlenia
219
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Use 4 heat inserts M3x4(L) x 4.6mm or 5mm (OD)
where the corpus will mount 

included step file if you want to mod it a bit

To raise your printer your can use the feet I made for it: here 

And you'll have to figure out cooling.
I personally mounted a 120mm fan to the cover plate mounting hole next to the PSU. Not very elegant but worked great.

-----

installing an octopus or any aftermarket board is not straight forward, because of the PCB ribbon setup, that has common ground with thermistor, so for example thermistor wire installed in reverse will lead to bad stuff (even though thermistor are polarity independent.)

------

Support me on Patreon so I can make more stuff!

https://patreon.com/squirrelf3d

or buy me a coffee
https://ko-fi.com/squirrelf3d
https://www.buymeacoffee.com/squirrelf

Tagi