1 / 2
BTT Octopus bracket for Fokoos Odin5-f3 — image 1
1 / 2

BTT Octopus bracket for Fokoos Odin5-f3

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

mount a BTT octopus in a Fokoos Odin5-f3 uses heat inserts You'll have to raise the printer, and lose the cover

Rating
0 / 5
Likes
4
Downloads
20
Makes
0
Views
219
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Use 4 heat inserts M3x4(L) x 4.6mm or 5mm (OD)
where the corpus will mount 

included step file if you want to mod it a bit

To raise your printer your can use the feet I made for it: here 

And you'll have to figure out cooling.
I personally mounted a 120mm fan to the cover plate mounting hole next to the PSU. Not very elegant but worked great.

-----

installing an octopus or any aftermarket board is not straight forward, because of the PCB ribbon setup, that has common ground with thermistor, so for example thermistor wire installed in reverse will lead to bad stuff (even though thermistor are polarity independent.)

------

Support me on Patreon so I can make more stuff!

https://patreon.com/squirrelf3d

or buy me a coffee
https://ko-fi.com/squirrelf3d
https://www.buymeacoffee.com/squirrelf

Tags