PI / MKS SKR Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my custom mount for a MKS SKR 1.3 Board on my Hypercube Evolution. It can also hold a raspberry PI, on which I…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 191
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my custom mount for a MKS SKR 1.3 Board on my Hypercube Evolution. It can also hold a raspberry PI, on which I run OctoPrint on. The two boards are connected over a direct serial connection via GPIO. I took the step on controll the SKR board only via OctoPrint so no Display is connected.
To cool everything a little I used 120 Fan which I had laying around. But this is optional until the driver handles voltages where they need active cooling.
There are two versions of the mount, since I also installed an optional beeper on the board.
For assembly I used M3 screws and nuts for the SKR and M2 for the PI. The extrusions I mounted the mount are 3030's.
Print Settings
Printer:
Hypercube Evolution
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
20%
Filament:
dasFilament PETG
Black
Notes:
I set support blocker on the screw holes, to save the time to clean them.
Category: 3D Printer Parts