Manfrotto 804rc2 replacement handle (Manfrotto R804,99)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement hand screw for the Manfrotto 804rc2 photo head. Handle grip for M8 bolt.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 360
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This model prints a “handle grip” around a 60mm x M8 bolt, enabling you to tighten the bolt with ease and without extra tools.
I designed it to fit the photo head of Manfrotto 804rc2, as the original 3 screws were lost, and I didn't want to pay $40 for replacement parts, when a standard M8 bolt would do (total cost less than $4).
You need:
- M8 bolt (fully threaded) x 60mm length
- M7/M8 rubber washer/gasket (insert between handle and tripod for a smooth connection)
- 3x M3 x 11mm bolts, no countersink
I chose 60mm for the bolt length, which results in a rather stubby and short grip, which is still usable. Modify the included design file, if you want a longer bolt and handle.
Printing notes
- Print the base standing up on its narrow end, with a brim. No supports are needed
- Print cap “the right side up”, with supports on the underside (side cutouts don't need them)
- 20% infill / 0.15 / 0.20 layer height
- Print time 2h20m