1 / 2
Thumb screw knob for #6-32 panhead screw and nut — zdjęcie 1
1 / 2

Thumb screw knob for #6-32 panhead screw and nut

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

As the title says, I wanted to use fasteners without having to find the screwdriver I set down somewhere.

Ocena
0 / 5
Polubienia
12
Pobrania
120
Wydruki
0
Wyświetlenia
691
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

I wanted to use fasteners without having to find the screwdriver I set down somewhere.  Now I can…as soon as I find it to tighten these things up.  Remix as you see fit for the fastener size  you need/want.  Backing it up with the captured nut insures it won't strip out the plastic if it were directly threaded into it.  It's fairly low profile and works splendidly.  I've printed them from PETG and PLA, but they seem heartier from PETG.  They are small enough there's not much need for infill, make it 100%.  I have support on the head side and print hex up.  What little support critters remain, crush under the pressure of make-up torque.  You will lose about 1/8" (3mm) of fastener length in the knob.  They print fast enough with .2mm layers.  Might even replace some PC screws with these.

Tagi