1 / 2
Nerf Rival 130 to 260 Pusher Motor Housing — zdjęcie 1
1 / 2

Nerf Rival 130 to 260 Pusher Motor Housing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Sleeve housing to fit 130 series motor in place of a 260 series motor.

Ocena
0 / 5
Polubienia
30
Pobrania
177
Wydruki
0
Wyświetlenia
1277
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

If you have a Nerf Rival belt pusher motor die, it is likely a 260 series motor with no readily available replacements. I designed a housing to use a 130 sized motor as a replacement. It has increased venting around the motor to allow most 130 vents to work (I tested with Krakens). Has channels to let the air go out the front and back. In a Perses, there is venting right out to the open and this is actually better than the 260 setup.  Open access to wiring terminals.  You can cut/trim the rubber padding that often is used on the original motors to keep them tightly in place. This prints with no supports.  I have fit this and tested on a Perses.  Works perfectly. Running a 130 Kraken motor, it increases feeding slightly. Compared with a stock Perses averaging just under 11 balls per second (at least on my chrono), this motor delivers 12 balls per second and peaking up to 14 balls per second. I would not replace the 260 for performance reasons, this sleeve is offered as a reliable and easy method to resurrect a dead Perses or other Nerf Rival full auto blaster using a 260 belt pusher motor.

Tagi