Nerf Rival 130 to 260 Pusher Motor Housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sleeve housing to fit 130 series motor in place of a 260 series motor.
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 177
- Makes
- 0
- Views
- 1,273
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
If you have a Nerf Rival belt pusher motor die, it is likely a 260 series motor with no readily available replacements. I designed a housing to use a 130 sized motor as a replacement. It has increased venting around the motor to allow most 130 vents to work (I tested with Krakens). Has channels to let the air go out the front and back. In a Perses, there is venting right out to the open and this is actually better than the 260 setup. Open access to wiring terminals. You can cut/trim the rubber padding that often is used on the original motors to keep them tightly in place. This prints with no supports. I have fit this and tested on a Perses. Works perfectly. Running a 130 Kraken motor, it increases feeding slightly. Compared with a stock Perses averaging just under 11 balls per second (at least on my chrono), this motor delivers 12 balls per second and peaking up to 14 balls per second. I would not replace the 260 for performance reasons, this sleeve is offered as a reliable and easy method to resurrect a dead Perses or other Nerf Rival full auto blaster using a 260 belt pusher motor.