1 / 4
Clip-on Fan Cover for Arctic F9 — zdjęcie 1
1 / 4

Clip-on Fan Cover for Arctic F9

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Fan Cover for Arctic F9, hopefully stopping it from gobbling up your fingers.

Ocena
0 / 5
Polubienia
2
Pobrania
24
Wydruki
0
Wyświetlenia
259
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

A Clip-on fan cover for Arctic F9. Just push this cover into either the front or back of the F9 and it will tightly snap into place.
This model was specifically designed to fit the Arctic F9, and I haven't tested if it fits any other fan models. It is possible that other 90mm fans are compatible.

I designed this because I had a few Arctic F9 fans laying around, and wanted to use them as a desktop fan. Although the fans work well, they are quite the safety hazard.
Therefore, to make them safer to use, I clipped these covers on both sides of the fan. Now my fingers are safe from the spinning death blade.

 

The model consists of a thin grid mesh that prints directly on the bed. You might run into problems if your bed adhesion isn't good. Though I had no problems printing on my glass bed at 60C.

There is a .STL file you can use for printing, and a source .blend file you can use to customize the model.

Tagi