Filament coil separator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this separator as a solution for coils where some plastic remained.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 1316
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
I made this separator as a solution for coils where some plastic remained. It is suitable for internal diameters from 8 to 11 cm (approximately) and is printed very simply and quickly. The last photo shows several prototypes that I made in search of a solution.
My tests showed a satisfactory result. I used one divider for two colors, but I believe that you can place three colors, for this you need to make a second divider. The most important thing is to gently wind the thread without overlaps. I did not test on a coil located horizontally, I am afraid that there part may cling to the thread, be careful.
Print instructions
Supports:
No
Resolution:
0.3
Infill:
40