Filament coil separator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made this separator as a solution for coils where some plastic remained.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 53
- Makes
- 0
- Views
- 1,316
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Public Domain
I made this separator as a solution for coils where some plastic remained. It is suitable for internal diameters from 8 to 11 cm (approximately) and is printed very simply and quickly. The last photo shows several prototypes that I made in search of a solution.
My tests showed a satisfactory result. I used one divider for two colors, but I believe that you can place three colors, for this you need to make a second divider. The most important thing is to gently wind the thread without overlaps. I did not test on a coil located horizontally, I am afraid that there part may cling to the thread, be careful.
Print instructions
Supports:
No
Resolution:
0.3
Infill:
40