Catrike Display mount for Eggrider V2 or SW102 for BBSHD or BBS02
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount I designed to place the Eggrider V2 display directly above the left (or right) handle of my Catrike…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 594
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This is a mount I designed to place the Eggrider V2 display directly above the left (or right) handle of my Catrike Dumont. It goes into the end of a 7/8" tube and should work for other trikes that use 7/8' handles. I wanted my display to be within easy reach so that I wouldn't have to take my hand off the handle while pressing buttons on the Eggrider. It's far from perfect but it does the job and looks halfway decent I think.
I printed the main piece on its side with the largest flat surface facing down (with supports). The other two lower pieces were printed vertically with no supports needs
This uses M5 hardware:
1 - Nut
1 - 25mm Bolt
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
100
Filament: Amazon PETG Black
Category: Sport & Outdoors