1 / 3
Toilet Paper Ply Divider Using Prusa MMU2S Spool Holders — zdjęcie 1
1 / 3

Toilet Paper Ply Divider Using Prusa MMU2S Spool Holders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you already have the Prusa Enclosure V2 with MMU2S support, then all you need is 3 small parts, a rubber band, and…

Ocena
0 / 5
Polubienia
26
Pobrania
23
Wydruki
0
Wyświetlenia
2339
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial

If you already have the Prusa Enclosure V2 with MMU2S support, then all you need is 3 small parts, a rubber band, and a board to make this handy toilet paper divider. This will come in handy, especially during the great toilet paper shortage of 2020, to help divide your ply's and stretch your TP to last just a little bit longer. Best of all, all parts are press fit so just pull them apart when you're all done and put your multi material setup back the way it was. Best of all, it only requires 4 of the rods from the spool holders so you're still left with one to keep on printing one color at a time. Kit comes with two different sizes for the rubber band holder to adjust for the right amount of grip or the right size for your rubber band to keep the two rolls in sync while you roll. The spool holders don't fit on a TP holder, but I'm sure you'r clever enough to rig up something for that too :-) I just set mine on the tank.

Print instructions

25% Grid Infill
2 Perimeters
3 Solid Layers Top and Bottom
0.25mm Layer Height

Tagi