1 / 3
Toilet Paper Ply Divider Using Prusa MMU2S Spool Holders — image 1
1 / 3

Toilet Paper Ply Divider Using Prusa MMU2S Spool Holders

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

If you already have the Prusa Enclosure V2 with MMU2S support, then all you need is 3 small parts, a rubber band, and…

Rating
0 / 5
Likes
26
Downloads
23
Makes
0
Views
2,339
Reviews
0

Updated at source:

Model information

Category
Bathroom
License
Creative Commons — Attribution — Noncommercial

If you already have the Prusa Enclosure V2 with MMU2S support, then all you need is 3 small parts, a rubber band, and a board to make this handy toilet paper divider. This will come in handy, especially during the great toilet paper shortage of 2020, to help divide your ply's and stretch your TP to last just a little bit longer. Best of all, all parts are press fit so just pull them apart when you're all done and put your multi material setup back the way it was. Best of all, it only requires 4 of the rods from the spool holders so you're still left with one to keep on printing one color at a time. Kit comes with two different sizes for the rubber band holder to adjust for the right amount of grip or the right size for your rubber band to keep the two rolls in sync while you roll. The spool holders don't fit on a TP holder, but I'm sure you'r clever enough to rig up something for that too :-) I just set mine on the tank.

Print instructions

25% Grid Infill
2 Perimeters
3 Solid Layers Top and Bottom
0.25mm Layer Height

Tags