1 / 1
Voron V0.1 Little Rubber Feet, Taller — zdjęcie 1

Voron V0.1 Little Rubber Feet, Taller

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Moves your v0.1 slightly higher so it won't wobble if something is under it.

Ocena
5 / 5
Polubienia
2
Pobrania
34
Wydruki
1
Wyświetlenia
446
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Voron v0.1 is built to such tight tolerances. If there is a spec of dust on the table under the z-axis motor, it will make the whole printer wobble. The solution is to move the printer higher off the surface. These replacement little rubber feet use the same 40mm screws as the original, but are 4mm longer to give more clearance to objects under the printer.

Print very slowly in medium hardness TPU (95A). Avoid stringing by printing them one at a time.

Add an M3 washer inside before securing them to the base of the printer.

 

 

Tagi