Prusa mini+ Lightbar Mod

Remix of a remix to fit this under counter lightbar: https://a.co/d/aLcCabf 

ASOKO LED Under Cabinet Lighting for Kitchen with Touch Sensor, USB Plug in Under Cabinet Lights, 12 inch Under Counter Lights for Kitchen,Daylight White 4500K, Under Desk Light

Dimensions: 0.78in (~19.82mm) W x 0.23in (~5.85mm) H x 12in (~305mm) L

------

Modifications:

• modified lightbar slot to fit lightbar dimensions (above)
• shortened the height of the mod, reducing material needed to print
• added wire guide to direct power cord to the extruder bar where it can be further guided to power source
• added two small holes for an M3 hex nut (only one needed) to prevent the lightbar from covering the power on/off/dimmer touch button

Parts:

• M5x20 (2x) - to secure mod to top of extruder bar. unfortunately like the original part, the stock M5 screws that come with the prusa mini are too short
• M3 Hex nut (1x) - not strictly necessary, but helps position the lightbar so the part does not cover the power button

Notes: 

Printed using Prusament PETG (PLA also is fine); sliced using PrusaSlicer.
Orient the model so the text side is facing the print bed.

Infill: 10% gyroid (5% or more should be fine)
Supports: recommended*

* there is a small overhang dug into the “top” (when printing) of the model for the M3 hex nut inserts. the supports may not be needed, but for such a small area didn't try printing the model without them. these can be easily be removed with needle nose pliers

TinkerCAD link: 
https://www.tinkercad.com/things/bYRqBc1OttW