Ortur Laser Master 2 Pro - Cable Support + AirAssist hose support

It bothered me that the cabling of the laser module on the Ortur Laser Master 2 Pro was sagging. Sometimes the (lighter) material placed under the laser was touched by this and shifted.

Therefore I constructed a cable support for the OLM 2 Pro. The connecting cable now rests on this support and the working area of the laser always remains free :-))

Since the cable support is about 50 cm long, I had to split it (left + right) because otherwise it would not have fit on my 3D printer.

I then glued the two parts together with the connector and super glue.

The support is fixed with one M3x6 and one M3x10 screw. 

I attached the cable holder to the laser module carriage with two M8 nuts.

The connecting cable was fixed with cable ties.

Update 1     03 Dec 2022

Since I now use a self-constructed AirAssist system for my Ortur, I have changed the cable support (now version v2): 

First, bottom and side walls are 2mm thick (instead of 1mm) to make them more stable. 

On the other hand I put a middle wall to separate electric cable and air hose when moving.

Of course, you can use the modified cable support without any AirAssist.

Update 2     28 Sep 2023

Both cable supports (left + right; now version v3) are slightly modified for better fit. They are minimally shorter with oval holes on the sides.

I have constructed a more stable connector_v3. My cable support with the old connector_v2 had bent downwards in the middle over time (due to the movement of the cable and air hose). I fixed the new connector_v3 in the middle under both cable supports with superglue; the 4 holes should match.