Mini-Afterburner CR-Touch Mount. [Afterburner Dong]

04/14/2023 - Updated/Uploaded v8
 - V8 is redesigned to be stronger around the m3x40 screw holes. I had some issues with mine cracking.  

11/3/2022 - Updated/Uploaded V7 
 - V7 features some design changes such as mounting the CR-Touch about 1.5mm closer to the bed by thickening the cr-touch mounting part. V1 would sometimes touch the bed angled forward if mounted improperly. The screw holes have been chamfered to allow the screw heads to set in more recessed to keep the cr-touch from angling forward.

Some printing recommendations: 

• Print in abs, asa or any type of high-temperature resistant filament.
• Printing with Organic supports in Prusa Slicer 2.6.0 has proven very successful for the small bridge it has to make.
• Printing with NO supports will work, just may be more finnicky.
• This is a short print, at about 20 minutes to an hour depending on your settings.
• Slower is always better
  
  
  Note:

1) Due to the extension to the front of the toolhead, if you're running an enclosed V0.1, the cr-touch may hit the front acrylic. This is one downside to using a cr-touch for bed leveling. It simply takes a lot of room within the build chamber. This isn't as big of a deal if you plan to print un-enclosed.

2) Due to the design of the Voron 0.1 Toolhead, and the positioning of this probe mount, the probe can't reach the back inch or so of the bed. Keep this in mind when you are configuring your bed mesh level.

Description:
This is a simple Creality CR-Touch mount for the Voron 0.1 Mini Afterburner toolhead. This can be a little bit of a tricky print due to the bridging. However, it shouldn't be too bad to print.

This design mounts with 2 m3x40 screws to the tool head. You will need (2x) m3 heatset inserts for the cr-touch side. Insert the heatsets from the top going down, and make sure they bottom out. You may need to clear the hole from melted plastic with a screw. The Cr touch screws mount from the bottom up into the mount with 2 m3x6 screws

I am sure their are better methods to probe the bed of a Voron 0.1, however I had two extra cr-touch's on hand and I figured I may as well use what I have available.
 

Some of my recommended config for Klipper using Fluidd is as follows:

[bltouch]     # enable for BLTouch - fast-mode
pin_up_touch_mode_reports_triggered: true
probe_with_touch_mode: True
x_offset: 0     # modify as needed for bltouch location
y_offset: -33    # modify as needed for bltouch location
#z_offset: 0    # modify as needed for bltouch or run PROBE_CALIBRATE
speed: 10
samples: 3
sample_retract_dist: 5.0  # Can be set lower, example 2.5 depending on height of bltouch from bed
lift_speed: 40
samples_tolerance_retries: 3
speed: 10
samples: 2

[bed_mesh]     # enable for BLTouch
speed: 150
mesh_min: 10, 10
mesh_max: 110, 86   #The V0.1 Toolhead can't reach the back corners of the buildplate
algorithm: bicubic
probe_count: 3,3   # 9 Points
horizontal_move_z: 5