Stand for RFIDeas RDR-805H1AKU Snap-In Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is one of those hyper-specific projects that I can't see anyone having a use for besides me, but if you need it,…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is one of those hyper-specific projects that I can't see anyone having a use for besides me, but if you need it, there's no substitute. So here it is: A blank version of a stand for this card reader mounting box [https://www.thingiverse.com/thing:4564723]. As you can see in the sample image, I knocked my employer's logo out of the left side, but you could as easily stick a business card or small plate to it. The mounting box for the card reader is friction fit, though it could be glued.
Because of the structure of the logo, I ended up printing this one facedown with supports enabled. If I were doing it again I would try to arrange it so that I can print it on the left or right side, and I might be able to get away with less support material.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.15 mm
Infill:
20% (gyroid)
Filament: Ultimaker Tough PLA Red
Notes:
The downward-facing angle of the cylinder was a bit rough. Next time I'll try to print it standing on the side to avoid supporting this angle.
Mounting box fit is tight. Be patient. :)
Category: Other