Intel NUC 8 or newer "Slim" SSD extender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an Intel NUC 8 or later extender to give "Slim" models an SSD mounting plate.
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 340
- Wydruki
- 3
- Wyświetlenia
- 2857
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is an Intel NUC 8 or later extender to give "Slim" models an SSD mounting plate. I used M2.5 heat set inserts on the top of the plate to interface with the existing NUC bottom plate, and M3 heat set inserts on the side for the plate to be connected to the shell. To connect the drive to the NUC, I used this cable from Amazon.
To assemble, use 25mm M2.5 bolts through the shell tabs and into the original mounting points on the main board. Then mount the SSD to the plate, connect the cables and carefully fold it down to not crimp anything. Finally, use short M3 bolts to connect the plate to the shell. You can use anything from about 4mm to 12mm. Finally, use the original case bottom and screw it onto the plate.
Be sure that all parts labeled "Front", including the original case bottom, are facing towards the NUC front (where the power button is).
Print Settings
Printer:
Creality CR6 SE
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
20% Gyroid
Filament:
Generic PLA
Black
Category: Computer