Bed Crossbar Mount for Rivian
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple bracket that allows you to mount a pair of Rivian crossbars in the truck's bed.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 123
- Wydruki
- 1
- Wyświetlenia
- 1716
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I have two pairs of crossbars (reasons), and don't like to leave the roof ones on, due to wind noise and efficiency. They are a bit cumbersome and take a decent amount of space in the frunk or gear tunnel, so I decided to create a mount that would allow me to store them out of the way.
This is printed in ASA for UV resistance and at 50% infill for strength. There are certainly improvements possible, but these are plenty strong for the task. I can pull extremely hard on the bottom one without it budging. I have no concern about these holding up.
You will need a couple of longer M6 bolts, as the stock ones are not long enough. Any should do fine. You should probably print a spacer, but for now I just turned the stock cup washers around.