1 / 3
90 Degree LED Strip Clip - Thumbtack or Pushpin mount — zdjęcie 1
1 / 3

90 Degree LED Strip Clip - Thumbtack or Pushpin mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount LED strips with Thumbtacks

Ocena
0 / 5
Polubienia
14
Pobrania
91
Wydruki
0
Wyświetlenia
461
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wanted to mount LED strip behind my dressers to light up the wall.

Designed for RGBW Waterproof LED Strip, made for thumbtacks with plastic heads. should work as is for most waterproof strips.

3mm between the two fingers, which are 11.5mm long.
Diameter of hole for pin is 1.4mm, indent for the head is 8.2mm.

Optimized to print at 0.45mm extrusion width with 2 perimeters, results in a solid plastic piece. Takes approximately 9 minutes to print a one, 2 units take 17 minutes, 3 units take 19 minutes, printing more than 4 at a time is most efficient, results in print time of 5.25-5.3 minutes per unit, print time is linear above 4 units.

Print on it's side. If you would like it modified to your required dimensions or shape, leave a comment, or send me a message.