Polaris Ranger Backup Camera Adjuster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angles the backup camera on a 2021 Polaris Ranger Northstar Crew to provide more visibility when backing up.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 494
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made these to angle my backup camera on my 2021 Polaris Ranger Northstar Crew after seeing that in the factory position, it points towards the ground and doesn't really give a good view behind the side by side.
These are just two simple wedges that go between the metal camera mount frame and the bed and uses the original screws.
For anyone wanting to remix or make their own, the angle of the wedge is ~11 to 12 degrees. That seemed to be the best middle ground angle to see behind the side by side, but still keep the ball hitch in view for connecting to trailers.
I was able to print the models in the orientation shown without supports in the screw holes. I printed in PLA at .2mm layer height. I increased the perimeter to 5 and infill to 30% as these will be subjected to a lot of vibration and I wanted them to hold up. Print time was 1H:22M with these settings.
I have no idea if this will work on other Polaris Ranger models as I don't have access to any to test.