1 / 14
KIM-1 Keypad
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a keypad case that I made for the KIM-1 replica created by user ralf02 on forum64.de.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 397
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a keypad case that I made for the KIM-1 replica created by user ralf02 on forum64.de.
Warning: Still work in progress and subject to change!
In addition to the printable components you'll need the following:
- 2 keypads with 16 keys each as shown (actually, you just need 1 1/2)
- 1 keypad PCB (not yet released)
- 1 SPDT slide switch, 2.54mm pitch
- 1 female pin header connector, 15 pins, preferably low profile
- 1 male pin header, 15 pins to match the female one
- 6 self tapping screws, 2x6mm
- labels printed white on black for the keys E, F, AD, DA, PC, +, GO, ST, RS
- double sided adhesive tape to glue the clips to the motherboard
The printable feet included here are not for the keypad but for the KIM-1 motherboard itself. You'll need M3 nuts and short screws for these.
Category: Electronics