1 / 14
KIM-1 Keypad
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a keypad case that I made for the KIM-1 replica created by user ralf02 on forum64.de.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 28
- Makes
- 0
- Views
- 397
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a keypad case that I made for the KIM-1 replica created by user ralf02 on forum64.de.
Warning: Still work in progress and subject to change!
In addition to the printable components you'll need the following:
- 2 keypads with 16 keys each as shown (actually, you just need 1 1/2)
- 1 keypad PCB (not yet released)
- 1 SPDT slide switch, 2.54mm pitch
- 1 female pin header connector, 15 pins, preferably low profile
- 1 male pin header, 15 pins to match the female one
- 6 self tapping screws, 2x6mm
- labels printed white on black for the keys E, F, AD, DA, PC, +, GO, ST, RS
- double sided adhesive tape to glue the clips to the motherboard
The printable feet included here are not for the keypad but for the KIM-1 motherboard itself. You'll need M3 nuts and short screws for these.
Category: Electronics