Joker Lithophane Pumpkin

This needs to be printed in two separate pieces. The first piece is the main body and the second one is the lid with the stem. A total of about 24 hours of printing.

No supports are required on either print.

I used 0% infill for the walls of the pumpkin and 20% for the base. 20% is also used for the light holder part of the main body. 10% infill for the lid and 100% for the stem to increase strength as this is used to lift the lid.

A quantity of 5 8x3mm magnets are required. 4 to hold the lid to the main body and 1 to hold the light.

Light that I used: https://www.amazon.ca/Flashlight-Rechargeable-Waterproof-Emergency-Travelling/dp/B0B5ZMJ9W1/ref=sr_1_1?crid=HTDVDDXWRCHI&keywords=Mini+LED+Flashlight%2C+COB+Rechargeable+Keychain+Small+Flashlight+Work+Light%2C+Waterproof+4+Light+Modes+Portable+Emergency+Light+with+Folding+Bracket+for+Camping+Fishing+Travelling+Walking+Night+Riding&qid=1667145099&sprefix=mini+led+flashlight%2C+cob+rechargeable+keychain+small+flashlight+work+light%2C+waterproof+4+light+modes+portable+emergency+light+with+folding+bracket+for+camping+fishing+travelling+walking+night+riding%2Caps%2C83&sr=8-1

I added the “fuzzy skin” feature to the stem to add some texture.

The lid required 13 colour changes as the stem goes deeper than the top of the pumpkin lid.