Joker Lithophane Pumpkin
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lithophane pumpkin that does not require any supports and very little infill
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 18
- Makes
- 0
- Views
- 322
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This needs to be printed in two separate pieces. The first piece is the main body and the second one is the lid with the stem. A total of about 24 hours of printing.
No supports are required on either print.
I used 0% infill for the walls of the pumpkin and 20% for the base. 20% is also used for the light holder part of the main body. 10% infill for the lid and 100% for the stem to increase strength as this is used to lift the lid.
A quantity of 5 8x3mm magnets are required. 4 to hold the lid to the main body and 1 to hold the light.
I added the “fuzzy skin” feature to the stem to add some texture.
The lid required 13 colour changes as the stem goes deeper than the top of the pumpkin lid.