Railcore II 300 ZL Electronics Box Corner Wago and Heatserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the https://www.thingiverse.com/thing:3542340 modified for heatset inserts. It's for WAGO 222s (old style). If…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 231
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is the https://www.thingiverse.com/thing:3542340 modified for heatset inserts. It's for WAGO 222s (old style). If you have the new style WAGOs (221s) print this one: https://www.thingiverse.com/thing:3914814
Initeq (Amazon) inserts will work fine, available here https://www.amazon.com/initeq-M3-0-5-Threaded-Inserts-Printing/dp/B077CJV3Z9
Print Settings
Printer:
Formbot Raptor 2
Rafts:
No
Supports:
Yes
Resolution:
0.2 layer height, 0.4 nozzle
Infill:
20%
Filament:
Atomic PETG
Notes:
Set up a support extruder since PETG supports are a bear. This is done with the same extruder you are using for the model, not a physical second extruder. (Of course, if you have a dual extruder printer, that's fine, but this is done with a single extruder). If you're using S3D, use the fff profile I have included here. I'm using a Forbot Raptor 2 for this, but it will be a good starting point for your printer.
Category: 3D Printer Parts