Hex Hook for Prusa Mini+ Vertical Extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hook designed to hang the HexScraper by visle on a Prusa Mini+ Extrusion.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 253
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
A hook for hanging the HexScraper (or other items) from the Prusa Mini+ vertical extrusion.
I added a flat surface to the bottom of the hook to print on. Make sure to print in this orientation so the layer lines run perpendicular to the edge that must flex to insert the part into the extrusion. I was breaking off that piece if I printed the other way.
To install, gently push the rounded end into the extrusion channel. You may need to pinch the rounded bits slightly to get it to go in. It should be a snug fit.
I had good luck printing this and getting it to work in both PLA and PETG with 100% infill, 0.10mm layer height. In both cases, it took approximately 20 minutes to print.
I pulled dimensions from the models by michalhosna and visle to create this. Thanks!