Vintage Ornate Knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modeled a old brass knob to match to have a pair
- Ocena
- 0 / 5
- Polubienia
- 47
- Pobrania
- 125
- Wydruki
- 0
- Wyświetlenia
- 509
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Modeled a old brass knob to have a pair for a drawer. (Cover photo printed in HobbyKing Copper Glitter PLA)
Print Settings (as set in "Ornate Knob Threaded M4.3mf"):
- 0.1mm Detail (used 0.25 Nozzle)
- 20% Infill
- No Supports Needed
- Avoid Crossing Perimeters
- Seam position Rear (and paint seam in threaded area to be a line, makes it easier to screw in)
- Skirt height 1 layer
- Brim width 6mm
- Brim separation gap 0mm
(I used a large brim so that the knob wouldn't come off the build plate.)
You may need to change your retraction settings so you don't get a lot of stringing as gcode has my retracting settings as is mainly there just for a time estimate for a high quality print.
Modeling Suggestions:
I made the knob to fit a M4 bolt but included a 3mf that has no threads to add your own.
I would recommend adding a negative offset to your threads so that's it not a super tight fit.
