1 / 3
Vintage Ornate Knob
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modeled a old brass knob to match to have a pair
- Rating
- 0 / 5
- Likes
- 47
- Downloads
- 125
- Makes
- 0
- Views
- 509
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Modeled a old brass knob to have a pair for a drawer. (Cover photo printed in HobbyKing Copper Glitter PLA)
Print Settings (as set in "Ornate Knob Threaded M4.3mf"):
- 0.1mm Detail (used 0.25 Nozzle)
- 20% Infill
- No Supports Needed
- Avoid Crossing Perimeters
- Seam position Rear (and paint seam in threaded area to be a line, makes it easier to screw in)
- Skirt height 1 layer
- Brim width 6mm
- Brim separation gap 0mm
(I used a large brim so that the knob wouldn't come off the build plate.)
You may need to change your retraction settings so you don't get a lot of stringing as gcode has my retracting settings as is mainly there just for a time estimate for a high quality print.
Modeling Suggestions:
I made the knob to fit a M4 bolt but included a 3mf that has no threads to add your own.
I would recommend adding a negative offset to your threads so that's it not a super tight fit.
