Ender 3 FreeABL Direct Drive
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This works with stock Ender 3 parts, however, I recommend making or buying a longer E stepper cable, 2 meters (1.5m is…
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 228
- Wydruki
- 2
- Wyświetlenia
- 3903
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
This works with stock Ender 3 parts, however, I recommend making or buying a longer E stepper cable, 2 meters (1.5m is too short for nice cable management). For instructions on FreeABL, please visit Thingiverse and Reddit for proper instructions. A firmware flash will be needed to enable mesh bed leveling with a manual sensor.\
This part can be used for direct drive conversion without FreeABL if desired.
Print instructions
Supports are needed, print with 40% infill with .16 resolution or higher. (.22 will not be strong enough over time)