Gas Metering Device - Sensor Housing for Reed Switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A housing for a reed switch of glas diameter = 1.8 mm and glas length of 10 mm.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 1216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Introduction
This is a housing for a gas metering sensor device using a reed switch. It may be used together with Gas Metering Device - Housing for PCB.
Reed switch
The housing is optimised for a reed switch with glas diameter 1.8 mm and glas length 10 mm. I used Reichelt KSK 1A87 Reed-Kontakt
Printing
Either use the gcode file provided or slice the stl file.
I used PLA, 3 perimeters and enforced some support of the housing.
After printing, remove the PLA support. Then install the reed switch and the cable as described in the attached pdf file.
Change it to your needs
Don't hesitate to change the housing to your needs. An OpenSCAD file has been attached.
Home automation
This project was influenced by Sebastian's Raspi Zero Housing for BK-G4 Gas Meter (Version 2)
The sensor can be connected to various home automation devices, I plan to use it in an Homematic environment, see Gas Metering.
Disclaimer
Use the housing on your own risk.