BK 5-24V Boost Converter Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just a small enclosure for a 5-24V boost convertor i purchased off of Amazon. They are pretty common and have…
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 41
- Wydruki
- 1
- Wyświetlenia
- 307
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is just a small enclosure for a 5-24V boost convertor i purchased off of Amazon. They are pretty common and have used these in the past and thought it might be nice if there was a protective case for it.
The lids do somewhat snap on and stay there, but I would recommend a drop or two of glue to keep them securely on if you are planning to set the potentiometer to a certain level and never change it.
10 pack of Boost converters: https://www.amazon.com/dp/B08R5LMQH1?ref=ppx_yo2ov_dt_b_product_details&th=1
There are 3 lids included... One marked 24V, one marked 12V, and one blank cover to allow customization on your end. Flip the lid 180 degrees (upside down) in your slicer to allow printing without supports.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.3mm
Infill:
20%
Filament: Sunlu PETG Black
Notes:
These converters get a little warm depending on their uses... I would recommend only printing in PETG, ABS, etc. I also used a .6mm nozzle, but .4 should be just fine and provide a cleaner looking part.
Category: Electronics