ADXL345 BLTouch mount for Ender 3 v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick remix I did of two models for a temporary mount for an ADXL345 X-axis
- Ocena
- 4 / 5
- Polubienia
- 34
- Pobrania
- 325
- Wydruki
- 2
- Wyświetlenia
- 1902
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
USE AT YOUR OWN RISK - Sounds a little dramatic, however if you use this mount then the end-stop switch will no longer trigger. Instead, the ADXL will crash into the motor cover.
To work around this, I just triggered the end stop myself when the print head was close. I only used this for tuning input shaper, then removed the mount.
This model uses the space from here: BLTouch Spacer/Screw Cover for Ender 3 Pro by onpdm - Thingiverse
I don't have a photo of it mounted, I'd removed it and started a new print by the time I realised I didn't have a picture. Only the one of me holding it next to where it should go.
ADXL345 - 15.21mm spacing
Print Settings
eSUN PLA+
0.28mm Layer