Converse Chuck Taylor for Ghosties!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Converse Chuck Taylor for Ghosties! Dual filament / colour.
- Ocena
- 4,833 / 5
- Polubienia
- 70
- Pobrania
- 213
- Wydruki
- 6
- Wyświetlenia
- 1491
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a dual filament / colour Converse Chuck Taylor sneaker set for the very cute and popular Ghosties! model.
Print Settings
Print the sole in whatever filament you like and the top in perhaps some more colourful filament. I recommend using a 0.40 mm nozzle and a layer height of 0.20 mm or less for best detail.
Print the parts in the directions I have placed them. I recommend using a brim for additional bed adhesion as the bottom area of the parts is quite small. Once printed, break off the support from the bottom part and sand it slightly if needed.
Installation
To install, first insert the toe “tab” on of the top of the shoe into the slot of the sole then press the two parts together. It snaps in place, you should not need any glue. Next, insert the shoes into your printed Ghostie of your choice, there are a bunch of different designs to choose from at the original Ghosties! design page:
All done! The Ghostie! below was printed in eSUN ABS+ Luminous Green and the sneakers printed in various eSUN ABS+ colours.
Parts printed on Qidi X-Max using Icarus 2 with Rapido K500 hotend and Sherpa Micro extruder.
Support
All my designs and mods on Printables are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)