Cable Holders. Choose Your GAP! With clips for screw mounting.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
There is a OpenSCAD version of this cable holder where you can customize everything here:
Customizable cable holder. OpenSCAD script
I have so many cables with such a diversity of diameters. So I made a collection of cable holders that fits at least my needs.
The side of the cable holder has a flat area so it is easy to align different sizes.
The gap sizes (measured after printing) are: 2.6 mm. 3 mm, 3.5 mm, 3.9 mm, 4.4 mm
I needed the cable holder with the largest gap to hold my keyboard cable (diameter of 5.6 mm) on my desk, as shown in one of the pictures.
With clips for screw mounting and "locks" for the 4.4 mm versions to keep cables in place.
Mix and match holders with clips. Use a single screw or three. You choose.
Print settings:
No supports
2 or 3 perimeters
4 top 2 bottom layers
0.2 layer height
+10% infill
Using concentric filled for solid layers and top layer gives the best results for the top curves.
For PrusaSlicer or Super Slicer, setting parameter solid_infill_below_area to 35mm² will save filament and printing time.