water meter - AI on the edge - 50mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
50 mm water meter mount for an esp32-cam with a developer and a 120 degree lense, used for the AI-on-the-edge project
- Ocena
- 4,5 / 5
- Polubienia
- 33
- Pobrania
- 458
- Wydruki
- 3
- Wyświetlenia
- 3410
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This mount is used to place an ESP32cam above your water meter and read the value with the AI-on-the-edge project (https://github.com/jomjol/AI-on-the-edge-device).
I needed a lower mount for my 120 degree lense on my “richter” branded water meter and had better results with a consistent brightness so I chose a fully closed design.
The ESPcam box got a bit bigger so I could use a developer board to connect usb power.
I ended up adding a simple diffusor by printing a 20x5mm cylinder in super slicer in clear petg and a black top layer and glued in under the LED to get rid of the worst reflections.
prints without supports
added parametric cad files so you can modify the height to your needs