PRUSA like - Raspberry PI 4 case with a 40x40 fan and bracket for MK3/S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PRUSA like - Raspberry PI 4 case with space for a 40x40 fan and a bracket to clamp the case to the frame of the PRUSA…
- Ocena
- 4 / 5
- Polubienia
- 18
- Pobrania
- 178
- Wydruki
- 2
- Wyświetlenia
- 1829
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
PRUSA like - Raspberry PI 4 case with space for a 40x40 fan and a bracket to clamp the case to the frame of the PRUSA i3 MK3/S
In mi case i used a 40x40x20 fan i had lying around (12V from embpaspt) connected to 5V for reduced noise, you could use a NOCTUA 40x40x10 5V if you wish
SCREWS:
2 x countersunk M3 up to 6mm in length to hold the bracket to the case
2 x M3 with 5 to 8 mm in length to hold the bracket to the frame of the PRUSA
4 x M2.5 with 22mm length to hold the fan (my fan is 20mm thick if you're using a 10mm fan use a 12mm screw)
4 x M3 (15 to 20mm in length) to join the top and bottom of the case
As i'm not using nuts you could probably use M3 screws all around if you haven got the M2.5
The same happens with the lenghts, you could get away with different lengths but the ones listed are the optimal screws i designed the case with
Print instructions
I used PRUSAMENT PETG JET BLACK (the same PRUSA uses in their printers)
I used supports on the TOP part of the case (screw holes and fan dock)
Find attached GCODE for PRUSAMENT PETG for the PRUSA i3 MK3S and the 3mf file.