1 / 4
22mm Fan Frame for Noctua A12x25 (FormD T1) — zdjęcie 1
1 / 4

22mm Fan Frame for Noctua A12x25 (FormD T1)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

With this mod you can fit Noctua A12x25 fans on a xspc tx240 radiator in a FormD T1 1.1 (thx to eedev for the og model)

Ocena
0 / 5
Polubienia
9
Pobrania
68
Wydruki
0
Wyświetlenia
1959
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

This model is based on eedev's fan frame with the pogo pins on the side. In my case i didn't need the cutouts for the pogo pins as I was using the original cables and it was harder to print with supports in PETG. So I removed the cutouts, changed the wiring tray and made the inner hole diameter 11mm, which is perfect for pressure fitting the fans.

So here is what you do (also check photos):

  1. Grab some pincers like the blue ones that come with many 3d printers and cut the 4 struts of the frame
  2. Now you need to cut all material around the brass pin to eventually remove all material around it (Take your time on this one and watch out to not damage the pcb)
  3. If you successfully removed all material and the brass pin lays free you can fit it in your new 3d printed frame

I used these screws to secure the fans to the radiator, but i'll add a model which works with the standard 6-32 screws, which come with most rads soon.

Tagi