DJI Mavic Air 2 Mobile Phone Mount (Regular and Large)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Helichrissi's Mavic Air 2 phone holder design. My goal for this remix was to make the holder a…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 463
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a remix of Helichrissi's Mavic Air 2 phone holder design. My goal for this remix was to make the holder a little more sturdy by adding more screws. I also wanted to create one that was slightly larger to accommodate my phone with an Otterbox case. I added four screws to attach the lower part of the holder to the base and also added a center screw to attach a clamp to keep the base from slipping off the controller. Finally, I designed a thumbscrew to allow for toolless assembly and disassembly of the mount.
What to Print
- 1 -Base
- 1 - Holder Bottom (either regular or large but not both)
- 1 - Adjustable Slider (either regular or large but not both)
- 1 - Clamp
- 2 -Thumb Screw
Additional Supplies Needed
- 4 - M3 x 12MM Socket Head Cap Screws
- 4 - M3 Nuts
- 1 - M4 x 30MM Socket Head Cap Screws
- 4 - M4 Nuts
Print Settings
Printer Brand: Creality
Printer: CR10S PRO
Rafts: Doesn't Matter
Supports: Yes
Resolution: 0.2
Infill: 30%
Filament: Hatchbox PLA Grey
Notes:
I used rafts because I was getting some warping on the larger parts; however, they may not be required if you have a different setup.
Category: R/C Vehicles